High carbon steel contain carbon

Which nut can be rotated by finger

hacksaw blade teeth are

Turnbuckle is

Melting point of steel?

7 x 19 cable means

—- is high in hardness , strength, and corrosion resistant properties

Inconel is

Aircraft flaring tool must have flaring angle of?

The most common rotating beam or rotating cantilever test of the the material

The thickness of cadmium platting deposit is dependent upon the

The type of self locking nut currently in use are the

The use where the desired tightness can be obtain with the finger and where the assembly is frequently removed

Flare less tube installation

The plastic cannot be reshaped once being cored by heat

MTCS

In needle bearing

Which rivet are used in the interior of the aircraft where clearance is not required

The strength of which cannot increase by heat treatment

Type of damage and defect in composite

MTCS

In a simpler gear train

When copper wire is replaced by Al wire

Shearodising carried out by heating the part in a closed rotating chamber containing

The hardness test is made with a diamond penetrator in the form of square base pyramid

Which has high electrical & heat conductivity, meallable and ductile –

Advantage of threaded fastener-

Brinell tester-

Taper roller bearing raceways-

Elimination of—— stops electrochemical corrosion-

Single raised dash on bolt

Turnbuckle

Light drive fit-

Which is used for balls and rollers of antifriction bearings -?

Rockwell tester

Clad aluminum hardness –

Fatigue limit of steels –

MTCS Mg-

Aluminum fitting colour-

Fluid lines are marked with

ln bearing, radial internal clearance-

Application of self-lock nuts-

Which is used for aircraft repair works-?

Thickness of coating in conducting & non-conducting bases measured by-

Difference between AN/AC fitting

Material can’t be hardened by heat treatment-

Which is used with phosphate ester hydraulic fluid-?

Which rivet is used to take excessive sheet –

L-shaped fabric sewed from-

Which has excellent resistance to petroleum products?

Which nut is used in assembly frequently removed-

MTCS

Fillers-

Higher tensile strength-

Stainless steel spring-

Belleville springs-

Rivet used for magnesium structure-

Internal gear

MTCS

Rivnuts-

MTICS-

When metal dipped in electrolyte which will corrode-?

Corrosion in accordance with SRM-

Aircraft components are tightly pressed together by-

Soldered flux copper brass

To make wires carry same current-

1100 Rivet used for-

Lock bolt-

lock washer never used on-

Surface tape-

Which is most common to detect defect-?

Quick disconnect coupling